Page 1534 - MISUMI SINGAPORE Economy Series

Economy series Product Overview Instructions Economy series
Cartridge Heaters Cartridge Heaters

vs Standard Type QMounting Method
Saving
Economy series up to
Cartridge Heaters 80 % One side within 0.05mm · Please minimize the installation clearance of
the heated metal block
When machining the metal block mounting
High quality raw materials, Mounting Hole holes, it is recommended that the one-sided
clearance is 0.05mm or less
(Reamed Hole)
life and quality assurance * The tightness between the heater and the object to be heated
affects the life of the heater. Moreover, the large gap will
Stock items will be shipped prolong the heating time and slow down the response speed of
temperature control. Drilled holes can also be used, but
reamed holes are recommended for all heater mounting holes.
on the same day at the earliest * The service life of the heater will change greatly due to the
usage environment. Improper operating temperature,
temperature adjustment methods,etc. may result in
disconnection within a short time period, so it is recommended
to prepare a spare cartridge heater in advance.
Cartridge Heaters

22 QFeature Q Example of Use
· It is a long-life and high-power heater, which is most suitable for heating metal plates as the main purpose.
Heaters / Temperature Sensors / Heat Insulating Plates · MISUMI Economy series heaters standardize the specifications that are frequently used in the market, and
can meet the needs of users to shorten the delivery time.

Q Basic Composition (Example)
A complete set of goods are available in MISUMI Economy series, realizing one-stop purchase.
As shown in the figure below, the heater should be used in combination with the temperature sensor and the
Cartridge Heaters temperature controller.

P.1529 Control Output · Relay Control Object Cartridge Heaters
Temperature Sensors · SSR Cartridge Heaters P.1532 Cartridge Heaters P.1532

P.1532

P.1537 Metal Plate
Temperature Controllers Temperature Controllers Temperature Sensors

P.1553
P.1544
P.1551 Q Difference between MISUMI Economy series and generic products on the market Heating the water tank through metal plate Heating the press
Heat Insulation Plates Generic products on the market* MISUMI Economy series

P.1555 Cracked Surface Intact Surface QPrecautions for use
1 Do not leave the heater dry heating in the air.
2 Please prevent the wire and insulator part of the heater from water and wet or damp area, otherwise it
Equivalent 4000H Life Test*
may cause electrical leakage or short circuit.
3 The nickel bar at the root of the wire may break after repeated bending.
4 When taking out the heater from the heated object, please be sure to disconnect the power supply, and
do not touch the heater that has just been disconnected from the power supply.
Result Short circuited, damaged and can not be used Can still be used normally
5 Abnormal short ON→OFF cycles will adversely affect the life of the heater, and it is recommended to use
* Test method, pursuant to GB/T7287-2008 Standard a PID-controlled controller.
* Generic products on the market are similar products randomly purchased by our company from online or offline markets 6 Do not use power supply with a voltage exceeding the rated voltage (V).
* The test data are obtained through testing by our company, which are for reference only.
1529